View Single Post
Old 02-25-2007, 09:56 PM   #10 (permalink)
Wycke
Supernatural Anaesthetist
 
Wycke's Avatar
 
Join Date: Apr 2006
Location: Cheesesteak Country
Send a message via AIM to Wycke

Quote:
Originally Posted by sdawg View Post
The challenge I am facing is that the palmer's stabilizer that I have just came back from the shop. That's normally good, but it had a note saying that it is high-pressure... originally, I had this stabilizer on my pro/carbine, but I don't need it there after my switch to a HPA tank that has consistent output at approx. 750PSI.
With the adjuster screw flush with the bottom of the reg, it should be putting out approximately 500 PSI. Each full turn of the screw generates about 100 PSI difference (clockwise increases, counter-clockwise decreases). 500 PSI is as good a starting place as any, but if the internals are all stock, you'll likely have to go up to get decent velocities and efficiency.

-Chad
__________________
Porch Monkey 4 Life!

s'ok...I'm takin' it back...

My Feedback Thread
Wycke is offline   Reply With Quote