Thread: T8 mag issue
View Single Post
Old 03-17-2010, 11:17 PM   #4 (permalink)
MCB Member
Jackson's Avatar
Join Date: Jul 2006
Location: Pittsburgh, PA

Originally Posted by WidowMaker View Post
also check to make sure the long screws in that mag have not been over tightened...
In this vein...

Loosen the long screws and the little ones that hold the "valve" part of the mag to the mag. Then try to center up the valve and tighten the screws. Sometimes the valve part can seat a little off center causing the nipple to rub and the valve to rub on the inside of the grip. The grip has small raised lands inside that center the valve up to the nipple, and if the valve is off, the mag seats a little crooked and binds a bit.

My 3D Printed Products:
Retro 7 CO2 Knob Grips
Tiberius T15 Magazine Winding Tools
I do custom 3D printing and design work. PM me for inquiries.

Mission Masters
My Feedback
Jackson is offline   Reply With Quote