View Single Post
Old 08-22-2010, 10:53 PM   #1 (permalink)
Active Member
Join Date: Aug 2008
Location: HI
Send a message via AIM to xwiredx

86* Frame Trigger Pin Question

Hey guys,
I have a J2 Cocker with the CCM 86* hinge frame. I need to adjust the top set screw so my trigger pin does'nt keep sliding out. I was just wondering what the best way to do this is? Do you tighten it just enough that it barely touches the trigger pin but provides some resistance, or is it safe for me to just snug it down pretty good so I know the pin won't move out at all?

xwiredx is offline   Reply With Quote