Thread: tank spacer
View Single Post
Old 10-13-2010, 07:09 AM   #3 (permalink)
slowerpig81
Machinist in training
 
slowerpig81's Avatar
 
Join Date: Feb 2009
Location: St. Louis, MO
Send a message via Yahoo to slowerpig81

Thats what he's looking for, except with the male ASA output plugged. One way would be to drill and tap the top output hole for a plug.
I could also make one, and I was thinking that instead of leaving the pin depressor in the material, I would drill a flat bottom hole and then drill a small through hole right in the middle from top to bottom to be tapped for a setscrew. This would be installed and loctited in, allowing for an adjustable pin depressor.
__________________

Feedback/Avvy by Tessa Schrader
slowerpig81 is offline   Reply With Quote