View Single Post
Old 12-23-2010, 12:04 AM   #42 (permalink)
super_stanchy
The Man With No Plan
 
super_stanchy's Avatar
 
Join Date: Nov 2008
Location: Oregon City, OR

CCM Fan
PBN Fan
Quote:
Originally Posted by Mayhem View Post
That does look good. The tib barrel is a bit more complicated to create this for though. Unlike most barrels on the market it doesn't thread on, it has a groove cut along side that slides over a pin allowing it to turn up for a hopper or down for a mag.

It has a thicker sidewall for this, which makes milling easier, but the groove could be an issue for tolerances.

I saw that another airsmith was trying to create something like this and gave up on the pursuit. I'm not sure what problem they actually ran into though.
well i'd love to figure out the dimensions....
its going to be bored out to .743-.745" and so as long as its not like .710 its ok

i did a mag twistlock to cocker adapter.... it exposed the detent grooves, but still works amazing
super_stanchy is offline   Reply With Quote