View Single Post
Old 10-28-2011, 11:14 PM   #3 (permalink)
Spider!
MCB Member
 
Spider!'s Avatar
 
Join Date: Dec 2008
Location: Houston, TX

Thanks! It's relatively easy with a drill press. The edge of the hammer lines it up in a vice and the bottom is 3/8" wide, which is a standard roll pin length. I think the drill bit I used was 0.067, but the fit was still tight.
__________________
My Feedback

Last edited by Spider!; 10-29-2011 at 12:00 AM.
Spider! is offline   Reply With Quote