Tippmann 68 Special O-RING SIZES
Hammer and outer valve- 7/8 x 1 x 1/16
Power Tube- 3/4 x 15/16 x 3/32
Front Bolt- 9/16 x 11/16 x 1/16
Inner Valve Seats- 3/8 x 1/2 x 1/16
Linkage Rod- 5/16 x 7/16 x 1/16
ASA Pin- 3/16 x 5/16 x 1/16
*NOTE* these are behind the ASA pin and not visible unless you remove the fitting. If not leaking I would suggest them to be left alone,however if there is a problem be prepared to replace anywhere from 1-3.
Hope this Helps.
*REMINDER* This Marker needs liquid CO2 to function properly,hope you have your syphon tank ready,I'd hate to see it all seal up and not performing the way you remember it,If you need any assistance PM me.
Last edited by Rolling Thunder 67; 01-11-2012 at 04:39 PM.
Reason: Forgot Info