View Single Post
Old 02-26-2012, 10:39 AM   #4 (permalink)
Home of the lama
WALZ's Avatar
Join Date: Nov 2010
Location: Naples, Idaho

Brass and Wood Fan
All you need to do is side-tap it with a 1/8 npt-28. You will also have to drill and tap the plug that the pierce pin runs through (8-32 or 10-32 can't remember right now). I use medium locktight to seal set screw. You will eighter need to cut the pierce pin off the valve pin or buy one for a c/a setup. If you are going to mount it on the grip frame you will need to make a solid 3/8 thick spacer to fit tight inside grip frame to mount to or buy a umb for it.
WALZ Feedback

The new sheriff in town.....
WALZ is offline   Reply With Quote