Thread: CCM S6.5 issue
View Single Post
Old 05-02-2012, 10:22 AM   #7 (permalink)
MCB Member
240SX's Avatar
Join Date: Nov 2008
Location: Newfoundland, Canada

Moved this to the CCM section.

Step 1) Clean the bottom tube. Take out the IVG, Spring, Hammer - clean the bottom tube with alcohol - do not lube the hammer when reassembling.

Step 2) Clean Reg - double check input settings - and check its recharge on your tester.

Step 3) Double check timing - make sure the back block is at 1/8th inch from the back of the body when firing in auto trigger.

Step 4) Give it a try - See if that fixed it - if not - and this is an odd one - check your trigger for excessive wear. If you have a HUGE divot in the trigger - order a new one. It can cause the AT to release early and cause odd issues.

Keep us up to speed - we will get this fixed!

I was going to say raise your dwell but maybe you should listen to Tal instead.
"Move swift as the Wind and closely-formed as the Wood. Attack like the Fire and be still as the Mountain."
Sun Tzu
username: bacreman, 100+, 100% positive Feedback
240SX is offline   Reply With Quote