View Single Post
Old 07-02-2012, 01:33 PM   #6 (permalink)
IrishRedneck86
Active Member
 
IrishRedneck86's Avatar
 
Join Date: Oct 2008

Well Im a welder and fabricator by trade but Ive been in and out of work and dont have access to a drill press or lathe any more otherwise I would be doing the conversion myself . Cause what I would do is widen the barrel for a 1/4inch down to make a shelf for the new .50cal barrel insert that was turned on the lathe to sit in and not lose it. the new feed tubes would basically be the same as stock just smaller inside diameter. The only thing I havent figured out is the mods for the elevator so it comes up to the right position.
__________________
IrishRedneck86 is offline   Reply With Quote