View Single Post
Old 08-24-2012, 06:12 AM   #1 (permalink)
Smiley
Original SWARM
 
Smiley's Avatar
 
Join Date: Oct 2007

Armed Forces Trainer improved Rear sight replacement

New one on the left. Most replacements I have seen made were almost exact copies of the originals which have a very thin area between the center hole and the notch at the bottom. This area is prone to cracking as shown by the strip of paper in the crack in the original on the right.Using an extra rear plug from an F2 and turning the rear od down to accept a press on knurled cap that captures the rear sight. This allows a smaller center hole in the sight so it is alot beefier where the originals crack. While making the new one I increased the notch and the dot size a bit, and it needed some brass so a bead front sight was in order too.



Stock sight picture:



New sight picture:








Last edited by Smiley; 08-24-2012 at 09:10 PM.
Smiley is offline   Reply With Quote