View Single Post
Old 08-26-2012, 05:32 PM   #18 (permalink)
Dive Dive Dive
worrptangl's Avatar
Join Date: Nov 2006
Location: Back in Da 808

Fan of EMR
Originally Posted by Elemental View Post
I'm bringing this thread back up because I bought this gun and its giving my the same problem.

I tried adjusting the screw above your trigger finger and switching to a non-beveled insert did nothing. And I don't have any larger o-rings to try. But I highly doubt its the o-ring causing the problem because the gun shoots (i.e. the hammer is released) before I even get the pump handle halfway forward again.

Any advice?
Your not holding the trigger are you?LOL

Seriously though check the trigger set screws. If the forward adjustment screw is to far back that could cause it to trip the sear too early. But you will have to adjust the the sear tripper also. you can't have it in too far and you have to make sure that the slope is facing rearward.
Originally Posted by Talfuchre View Post
I will lock this damned thread up if anyone posts that disgusting picture I saw once.
It like the CCM version of Two Girls One Cup.
I will ban folks.... I swear.
worrptangl is offline   Reply With Quote