View Single Post
Old 09-21-2012, 12:37 PM   #31 (permalink)
Pump_Action_Prophet
MCB Member
 
Pump_Action_Prophet's Avatar
 
Join Date: May 2009

Those clear feed necks arent too bad from what I've seen. As mentioned the only real problem I've seen with those is that they are infact too thick to fit in alot of the older style non clamping feed necks without sanding them down... Sanding them down too much is probably one of the factor's that actually leads to the failure of them in the first place. Is it a Rotor quality feed neck, no... but it does the job at the low end price point just fine.
Pump_Action_Prophet is offline   Reply With Quote