Thread: New service?
View Single Post
Old 09-23-2012, 09:23 PM   #7 (permalink)
Join Date: Jun 2008
Location: Milwaukee

Kilt Club
The first one is nice but it would look better if it was either an angle cut, so that the milling doesn't stop so abruptly.But also having an aluminum sled to complete the cut off milling would work.
TheePsycho's Feedback

Originally Posted by freebird View Post
lube the shaft and warm the o-ring up in your hand by rubbing it back and forth between hands. then it should go on easier.
TheePsycho is offline   Reply With Quote