View Single Post
Old 10-07-2012, 11:54 PM   #9 (permalink)
Jebs04
MCB Member
 
Jebs04's Avatar
 
Join Date: Feb 2011
Location: Walton, KY

Brass N Wood Fan
Kilt Fan
Palmers Fan
What i did for servicing these is took a 2x4 block of wood drilled a whole a little larger than the valve placed a rag over the whole put valve down in the whole with the rag between the block of wood and the valve (pin side down in the whole) making sure that were the air line goes in the valve is still exposed... then with a large alen key press the brass plate down until you can see the large alen key threw the air line whole and then place a smaller alen key in the air line whole... then this takes the spring pressure off the clip ring and makes it a little less difficult to remove with a o-ring pick... after the clip is out you can press down with the large alen key again and remove the alen key from the air line whole to service the valve...
__________________
Markers Owned Currently: 200ish
FEEDBACK
Facebook Page For General Paintball Museum
Jebs04 is offline   Reply With Quote