View Single Post
Old 10-08-2012, 08:16 PM   #1 (permalink)
Skibbo
Ask me about my
 
Skibbo's Avatar
 
Join Date: Oct 2009

PE Etha manifold/etha

FROM JACK WOOD:

Quote:
Originally Posted by Jack Wood View Post
Hi,
Yes the #10 seals off the inlet to the front section of the poppet that controls filling of the firing chamber and also supplies the IN feed to the solenoid.
The #7 seals the air OUT of the solenoid to the rear of the poppet that controls the position of the poppet. It it a normally closed solenoid.
Holes in the manifold:
Top - IN
Middle - OUT
Bottom - Exhaust
Jack

__________________________________________________ __________________________________________________ ___________________________________________
I've looked and looked to see if I can find any information on this.

I'm wondering if anyone can tell me how air flows through the manifold/solenoid from the regulator, then back through the manifold to the bolt so that the marker can fire.

specifically:

The three holes shown on the front face here (I know the larger 2 are screw holes)
I figure one is IN, one is OUT, one is possibly exhaust?


Also, is the #010 o-ring the both the input from the reg (assuming) and output the front portion of the bolt, while the #007 o-ring the input to the rear of the bolt that controls when the marker fires?

Thanks for any information you can give me.
__________________
Quote:
Originally Posted by heinous View Post
i find this easy to masturbate to
Designer of the first legit looking ego pump, the EgoP!
BUY IT HERE!!


Tinkerer/ Pump lover
Team Akkadian Paintball Squad
OK D-Day '09 - German 716th IR
FEAR THE TREES!
Feedback:
http://www.mcarterbrown.com/forums/f...ml#post1067010

Last edited by Skibbo; 10-11-2012 at 11:54 AM.
Skibbo is offline   Reply With Quote