View Single Post
Old 10-08-2012, 07:24 PM   #2 (permalink)
MCB Member
y0da900's Avatar
Join Date: Oct 2007
Location: Plattsburgh, NY

I haven't handled one yet, but I am assuming that the three small ports are a direct from regulator to the oblong o-ring on the top - this feeds the supply to the dump chamber. The other two are a feed to the solenoid - also from the reg, and the solenoid connection to the rear port which cycles the firing piston.


Page 19 in the manual has sort of a flow diagram. Reg goes to the front port on the top (oblong) which feeds both the firing chamber and the solenoid. One of the three on the front is for that connection, and another for the firing piston. Not sure what the third is for.

Last edited by y0da900; 10-08-2012 at 07:37 PM.
y0da900 is offline   Reply With Quote