View Single Post
Old 11-21-2012, 02:16 PM   #7 (permalink)
CarolinaPanthers13
Newbie
 
Join Date: Aug 2008

You sir, are fantastic! That was going to my first step, disassembling, cleaning, inspecting, and lubing. I will definitely check out those youtube videos, I have never encountered a slider frame before lol, and I will invariably get stuck somewhere else along the way too. As far as sanding goes, what grit would you start out with? I'm not sure how tight the tolerances are and I wouldn't to take away too much metal. Probably nothing to worry about, but I could see myself going ape and going to far haha. And stop around 2000 grit?

And I can't believe what a dummy I was with the banjo bolt! I even knew that one was smaller than the other. I got hung up thinking about the valves and such. And I havent touched an autococker in like three years haha. Rusty?

Last edited by CarolinaPanthers13; 11-21-2012 at 02:19 PM.
CarolinaPanthers13 is offline   Reply With Quote