Quote:
Originally Posted by WholemealDrop  any suggestions on what to use besides the Tippmann ASA/LPR? I like it just because I want this to be custom yet still true to Tippmann. While I plan on milling and smoothing most of the gun, the name milling on the side will stay. |
What I would recommend for an easy alternative is getting an ASA with two side outlets, run one outlet to the high pressure regulator, and on the other outlet use a right angle fitting and installing a high-quality lpr.
Here is my mostly-empty shell:
This area is normally raised up, it will need to be milled down flat. Mine is milled more than necessary because I swapped out the board and solenoid:
Same story on the other side:
Forward groove was for the airline originally, rear groove is for my battery wiring. I chose to stick the battery in my tank cover:
Milling to allow for later-style trigger:
I also used a low-pressure conversion kit on this marker, my operating pressure was in the area of 250psi.