View Single Post
Old 01-30-2013, 06:38 PM   #6 (permalink)
ApoC_101
Doesn't work for Avratech
 
ApoC_101's Avatar
 
Join Date: Aug 2007
Location: Vancouver, BC

Yea I'd go ahead and use a proper airbrush station setup with an easily adjustable low pressure regulator, pressure guage, disposable in-line filter and possibly a water separator for a small additional cost. that whole setup you can bolt to a board and put it at your airbrushing table, and then feed that with any HPA source regged down to 100 PSI. airbrush consistency requires dry, clean air, free of debris, and quick adjustable regulator at the station makes it easy to adjust the spray on the fly.
ApoC_101 is offline   Reply With Quote