View Single Post
Old 02-12-2013, 09:31 PM   #20 (permalink)
Ambassador of the sport
Join Date: Jan 2013
Location: North Carolina

Originally Posted by Menace View Post
Nope. This is pertinent to the secondary question, not the primary. That's for another day, likely close at hand. In the meantime, there is nothing in this thread treating of factory bore finishes, which is the question at hand. Thank you nonetheless.
No doubt, but there is tons of stuff in there on roller burnishing. The technical conversation went pretty deep late in the thread.
Jaws is offline   Reply With Quote