View Single Post
Old 02-22-2013, 05:24 AM   #8 (permalink)
Post Whore
foldadoom's Avatar
Join Date: Oct 2006
Location: Nuuuuu Zealand
Send a message via MSN to foldadoom

Originally Posted by Cunha View Post
non permanent loctite will work if that is what you have. 565 may be optimized, but based on empirical evidence that myself and numerous other members can provide, non permanent thread lock works fine.

Now, if you're going to try to get a non tapered screw to create a seal, or a non tapered crub screw, than you aren't going to get a seal. A tapered screw or plug will almost seal on its own.

If that little grub screw is loose fitting you might need to try to find a larger screw, possibly the screw is on the small side of tolerances, and the hole is on the large side (even without damage this can make a hole difficult to plug)

Good luck!
I will try the 565 first, it looks like it had a locking/sealant in it begin was a bit of an experiment, the identical thread grub on the other side of the body i could not remove, it really needs to sit flush with the body as a cover plate then goes over it.

foldadoom is offline   Reply With Quote