View Single Post
Old 03-03-2013, 10:06 PM   #9 (permalink)
MCB Member
biftip98's Avatar
Join Date: Dec 2007

So this is where I'm currently at:

Uploaded with

I've added an xvalve, a black emag body, and any old school plastic frame with eclipse pops on/off. The macroline setup doesn't seem to bother me as much as I though it would. I haven't played with it yet, but its relatively comfy.

I still need to get some good twist lock barrels or perhaps doc's cocker thread adapter so I can use all my cocker barrels on it.

However, now I have two issues.

First the sight rail still doesn't seem to want to go on the body. I am afraid to force it on because I don't want to scratch the body up. I tried to use electrical tape, but that didn't work.

Second, the gun doesn't fire. I think the cause is that the sear pin doesn't go back far enough when the trigger is pulled to release the bolt. However, I am not sure about this because I only have limited knowledge of mags. Anyone have any ideas on this?
biftip98 is offline   Reply With Quote