View Single Post
Old 03-13-2013, 05:10 PM   #10 (permalink)
scribbleheli
Active Member
 
scribbleheli's Avatar
 
Join Date: Mar 2013

Sorry, bad wording. I didn't change the detent. Just applied my "fix"
and if you take out the detent. (you know, the tiny little sliver of plastic 1/8 of inch wide and like half an in long)

Cut a piece of double sided foam tape that exact size, then cut off some of the end that would go under the barrel o-ring, and stick it to the denten. replace the detent into the barrel. then place a small piece of scotch tape over that, but make sure not to inter-fear with the barrel O-ring.
scribbleheli is offline   Reply With Quote