Thread: Shop Talk!
View Single Post
Old 03-29-2013, 03:26 PM   #194 (permalink)
AbeShip
Aggalicious
 
AbeShip's Avatar
 
Join Date: Mar 2009
Location: Lovettsville VA

Here is the picture right side up


He used some thing to put the collets in and tightened it down with a wrench. I usually see the draw bar thats why I was curious as to what he was using. Almost like a chuck for collets. I will be checking the run off (have a mag base and indicator), what should I use to test it off of in terms of what is in the collet/spindle? He cut steel with it and it cut just fine. DRO works on it, power feed worked well. I will check the play in the table, along with the coolant to see if that works/is useable. It also has the 6 inch rise block on it.
AbeShip is offline   Reply With Quote