Thread: Honing question
View Single Post
Old 03-30-2013, 08:06 AM   #5 (permalink)
Vitalsilence
engineer minded
 
Vitalsilence's Avatar
 
Join Date: Aug 2012

Quote:
Originally Posted by joedirt199 View Post
depends on how deep the scratchs are. if they are just through the finish or deeper then you may need something in the 600-800 grit range. that 1200 grit will not go through the anno unless you just leave it in one spot for a long time.
The scratches are pretty bad but I didn t know if I should order 600 or 800 was unsure cause I don t want to take to much material off just smooth it out a little.
__________________
Ebay Feedback %100 positive
MCB feedback
PBNation Feedback
IOG
Also on customcockers

Quote:
Originally Posted by Nuke View Post
Some people are penny wise, and dollar foolish.
Vitalsilence is offline   Reply With Quote