View Single Post
Old 04-26-2013, 03:58 AM   #4 (permalink)
bob_wuzza
MCB Member
 
bob_wuzza's Avatar
 
Join Date: Nov 2008
Location: Grande Prairie AB

I've dealt with these regulator on a weekly basis and 100% of the time it was the o-ring on the brass piece where the red reg seat is in... Even if that wasn't the original issue they always got chewed up while putting the damn thing back in. I would grease the living hell out of it and replace it with the purple dye 010 oring. And while adjusting it screw it in till it seats ( not too tight or you'll dent the reg seat ) and slowly turn it out till you reach desired velocity. When you go too far it will chew the oring and you'll repeat the process over again
By far my least favorite reg
__________________
Big Whoop, I'm spooning a Barrett .50 cal, I could kill... a building!!! - Sterling Archer
Feedback
bob_wuzza is offline   Reply With Quote