View Single Post
Old 05-18-2013, 12:35 AM   #6 (permalink)
Summer's a-commin'
cobyrne's Avatar
Join Date: Feb 2008
Location: Dunedin, NZ

I just use an unmodified screwdriver - rather than levering the flat bit against the pin and turning the handle, put one side of the screwdriver tip into a notch and the other side of the tip against the inside wall of the pierce pin and 'push' the notch around in a clockwise direction. Works fine and you can use nearly any sized flat head screwdriver.
MCB Feedback
cobyrne is offline   Reply With Quote