Professionally I am a mechanical designer and drafter. If you have an idea that you want to turn into a 3d part and drawing, I can do that.
I have several projects that I have done here on MCB. The two that I think of right away are: Ace of Spades barrel project
My Phantom undercocking kit (can't find the thread at the moment, will replace with link when I do find it)
There is also my Tippmann Factory F/A rebuild thread to show that I will complete the project. Factory F/A, shoe shine and a tune-up
I am looking to raise some funds to buy a larger mill and lathe than what I have. I'm looking to make a buck, but only enough to fund these purchases. Rates will be reasonable, nothing like what it would cost to get a drawing done in the real world.
Post here or PM me.