View Single Post
Old 07-31-2013, 06:26 PM   #61 (permalink)
TheePsycho
Sadist
 
Join Date: Jun 2008
Location: Milwaukee

CCM Fan
AKA Fan
Kilt Fan
Just shipped out the Sterling today.

The requested work was for pressing a delrin sleeve in the pump handle one is in there or if you want to make a new one closer to the OD of the barrel that's cool too. Also having both pump arms the same length when fully threaded.

Also in there is a hardline for air if you can get that to work that would be cool otherwise I'll scrap that and the fittings.

-Thanks Travis
__________________
TheePsycho's Feedback

Quote:
Originally Posted by freebird View Post
lube the shaft and warm the o-ring up in your hand by rubbing it back and forth between hands. then it should go on easier.
TheePsycho is offline   Reply With Quote