View Single Post
Old 08-03-2013, 11:29 PM   #4 (permalink)
CCMachinist
MCB Member
 
Join Date: Oct 2007

CCM Fan
IIR the cam pins are all the same length.

There is not a longer pin in the shop.

There could be polishing compound in the small pin hole or bead blast in the hole.

we clean the holes out with a 1/16" drill

If you don't have a small drill a small paper clip may help clean it out.

Also most hardware shops carry 1/16" drills probably 2 or 3 bucks.

If that is not the issue call the shop on Monday.
__________________
“Do not yearn too much for a sword made by a famous smith. This is because even if you give a good man a sword worth ten thousand coppers, he will not be able to beat a hundred men each holding a spear worth a hundred coppers.” - Asakura Takakage Toshikage, 1462-1482

Ecc. 9-10
Whatever your hand finds to do, do it with your might; for there is no work, nor device, nor knowledge, nor wisdom, in the grave, where you go.

NEW STORE http://store.chipleymachine.com/

DOOR GUNNER handgun mounts for gunsafes.

http://www.machineshopdpm.com/
CCMachinist is online now   Reply With Quote