Quote:
Originally Posted by dsergison  http://sergisonmachine.net/images/lever05.jpg
there is a stainless tube running up the inside of the frame, and into the valve body through a little port.
I wish I could say an o-ring sealed port, but alas it's actually hard soldered to the valve. such that removing either requires sliding the new style valve out the back still attached to the line. |
Hey dan! (welcome aboard) Thants pretty cool. I never saw an air through gripframe before on a pgp. When the valve is soldiered to the line, is there a slot cut along the length of the lower tube? Also is the end of the original co2 chamber sealed at all or does the valve allow you to just hook it up and not have to worry about it leaking out the piercer?
(and do you make those pump handle setups?)
III