View Single Post
Old 04-02-2008, 10:18 PM   #24 (permalink)
MCB Member
Join Date: Oct 2007

Originally Posted by JOESPUD27 View Post
I'm interested in a RF S6.

Is there a way to make the hopper sit lower?

Can/could it tilt inward like Shiba-Kun suggested?

I liked the RF S5 bodies, but the hopper sat too high, IMO.

There is not much we can do with that design.It's about as low as we can build it.We were talking about going to 90* (straight in the side) but that could present it's own problems.As far as tilting inward it wouldn't be on this run.We will take a look at it and see what we can come up with.
“Do not yearn too much for a sword made by a famous smith. This is because even if you give a good man a sword worth ten thousand coppers, he will not be able to beat a hundred men each holding a spear worth a hundred coppers.” - Asakura Takakage Toshikage, 1462-1482

Ecc. 9-10
Whatever your hand finds to do, do it with your might; for there is no work, nor device, nor knowledge, nor wisdom, in the grave, where you go.


DOOR GUNNER handgun mounts for gunsafes.
CCMachinist is offline   Reply With Quote