Ok, I am new to the VM. I already know I will not be parting ways with them. I am was trying to get the velocity up a bit and know already I have to make an adjustment to the hammer(?).
But my question today is not about that. I have done my reasearch (I think) and as I was adjusting the bolt velocity. Setting it seemed there was no turn left for velocity up, or right for velocity down. I was more of a turn a bit this way and it would go up if I turned a bit more it would go down turn it back a bit and it would raise a bit.
I was kind of confused and was hoping there wasent something wrong, and this is how it is? Thanks in advance for any knowledge, you guys are willing to bestow upon me.
P.S. Any other tidbits of information are also welcome.
