Quote:
Originally Posted by Moosepatrol  Okay got the three way orings replaced and gassed up my cocker (note to self install top hats so I don't have a hose whip my finger again), so it holds air, but back block goes back to cock the gun but stays there. Now a previous post stated this is probably having the hoses in the wrong places correct? Also I think my three way rod might not be catching the front airway on my three way. I read in an autcocker timing guide to push the trigger rod all the way against the three way rod and tighten the allen screws. Is it possible I have also shortened the travel too much? |
Glad to hear you got the seals.
You may have the hoses on incorrectly - for a slider frame, the hose off the front of the ram should be on the rear-most 3-way barb, and the hose off the rear of the ram should be on the front-most barb.
You didn't use the 3-way shaft in the seal kit, did you? If so, that's your problem. The o-ring spacing is way too far apart for modern 3-ways - I believe it fits the really old-style 3-way, the one with c-clips.
Take some pictures, if possible, of your setup. As a last resort, you can ship the gun to me and I can take a look at it. Seriously, if you want, I would love to look at it for you.
A pic of the 3-way hose setup:
http://www.freewebs.com/jordan98/IMG_0957.jpg
Jordan