I just modded some Stock WGP Trigger Plates and will sell them along with the Autotrigger
20 each, this will make the drilling of the pump rod only mod needed
DISCLAIMER, these are not drop in and require some tuning/adjustment.
To Order email me at koaisaok@gmail.com Frames that my Autotrigger Fits:
Slider frames:
Benchmark, Belsales, Dye, KAPP, Freeflow, ANS, and more
Pivot/Hinge frames:
DYE, 32 degrees
Frames that my Autotrigger Does NOT fit:
Slider frames:
WGP Sliders(requires modding)
Pivot/Hinge frames:
Eclipse, Kapp Reflex, CCM Frames
Autotrigger $50
Trigger Plate Modification:
based on excess metal in plate and plate hardness
Stock Slider Trigger Plate Modification $10
ANS Trigger Plate Modification $20
AKA Trigger Plate Modification $50
turnaround is about 3 days
Drill & Tap Pump Rod for Lever Screw
$10 turnaround is 1 day FAQ What pump kit mods are needed for an autotrigger?Pump rod with hole drilled into it.
What MODs do DYE Pivot frames need for an autotrigger?NONE!
What MODs Slider frame need for an autotrigger?just make sure the surface is flat like in the pic...and it clears the Safety hole and you'll be OK
Autotrigger Instructions click me
I use Titanium Putty from Devcon, it does wear off a little but i have had the same slider with Ti Putty for 2 years and haven't had to replace the putty yet, also it slight wears the cam polishing it like how 600 grit paper would....i have been using a cam 10 years old (using the putty plate for 2 years) and its still ok
modding your own trigger isn't that hard
The Autotrigger Strikes Back!!! thread has information, and i would much prefer
you to do it.
HOW TO ORDER!!!
1) Figure out what frame you have (45 slider, Dye/32 degrees Pivot, Stock Sniper2 pivot(non 45 frames) ONLY!!!!)
2) Decide if you need your pump rod modded
3) email me your order to
koaisaok@gmail.com
4) if needed Send necessary parts for Modding
DISCLAIMER, these are not drop in and require some tuning/adjustment.
To Order email me at koaisaok@gmail.com