Quote:
Originally Posted by weekendballer  go to home depot and pick up a thread gauge while your there so it doesn't happen again. | Will look into the thread gauge. How much do they generally run? Quote:
Originally Posted by hvacman250 What is it going in exactly? It's the back part of the frame to body screw. Standard frame mounting screws on a cocker are 10-32. If they went larger, next logical step would be to go 1/4". 20 thread count is common, but 24 is available. The hammer lug is 1/4-28.
Give some details before I go into a full paragraph  I don't know where to start with information. I was hoping for a tip of some sort i.e. shove clay down and twist to get the "imprint" and such (bad idea). | I will try to get better information.
FYI: I was planning to purchase it from you hvac.
__________________
Winchesters 50rnd Hoppers $4
3.5 tanks w/ valve $23
Dealer for: CCM, CCI, CP, and other misc companies.
Purchase here: Snap Paintball
I am not the owner of snappb.
Last edited by xkpxfatassxx; 05-12-2008 at 12:03 AM.
|