View Single Post
Old 07-06-2008, 11:46 PM   #14 (permalink)
CCMachinist
MCB Member
 
Join Date: Oct 2007

CCM Fan
burrs?

Quote:
Originally Posted by Talfuchre View Post
Andrew is right.

One - I don't recommend doing this unless you absolutely need to.

Here is what I did - and I hope Bill weighs in on this.

I used a small bit of emory cloth taped on a dowel and carefully and slowly rid the bottom tube of the bur and then used an old battle swab and some polish (Brasso) to smooth that area back. I would wager I barely took off any material as the anno was barely polished in all areas that was not the burr.

TF
TF,I don't have a clue.I haven't heard of this till now.Untill we get a marker back and inspect it,it would be difficult to say what is causing it.
I would think dry lubes in the lower tube would be better than oils or grease as they don't attract and hold dirt and grit? I am just guessing at what is going on.As far as the burrs goes??

One question.Is this a polished gun or dusted?
__________________
“Do not yearn too much for a sword made by a famous smith. This is because even if you give a good man a sword worth ten thousand coppers, he will not be able to beat a hundred men each holding a spear worth a hundred coppers.” - Asakura Takakage Toshikage, 1462-1482

Ecc. 9-10
Whatever your hand finds to do, do it with your might; for there is no work, nor device, nor knowledge, nor wisdom, in the grave, where you go.

NEW STORE http://store.chipleymachine.com/

DOOR GUNNER handgun mounts for gunsafes.

http://www.machineshopdpm.com/
CCMachinist is offline   Reply With Quote