Paintball

[Heebs]

So I want to know if a Tac One Warp left body and Tac One rail (?) will work with that AGD ASA that mounts via the rear frame screw right under the valve?

I'm not exactly sure what the ASA is called so I need some help getting that part, anyone got one?

This is what Im talking about

[Sneaky Sir]

You most likely would have to have your rail drilled for the mounting holes for the ASA but other then that yes it should work.

[Chemical-X]

those were called donkeys or under bottle if I remember correctly. I am not sure if newer rails are machined with the option of adding the under mount anymore

[sniper15]

I've got one AM/MM rail with the holes for it, and one without. I had one of those asa's for awhile. Don't know what ever happened to it...

[Heebs]

Am I limited to certain rails for the Tac One?

[BigEvil]

You need a rail with the rear slot. Any Venomous Designs or RPG rail should have them. The stock AM/MM rail will work also. The AGD RT length rails are all angled upwards in the back and do not have that slot. I dont think you can use the newer tac1 rail either.

[3L1te hax]

Are they just standard ASA holes? like for any old on/off or dropforward or whatever?

[Daze]

You'll either have to mill the back bottle holes into the tac-one rail, or mill the warp slot into a standard rail (and the tac-one rail, if it isn't warp ready). But yes, any rail will work with any body except the old original RT rails.

[b-cuzz]

Originally Posted by 3L1te hax

Are they just standard ASA holes? like for any old on/off or dropforward or whatever?

No. They're about 3/16" closer together than standard duckbill/bottomline ASA's. Unfortunately. Also, the screws that attach the AGD back-bottle adapters are threaded into the ASA from the inside of the rail.
However, with a bit of patience and the right tools, a DIY-er could likely thread the holes for a standard ASA into the bottom of the rail. Carefully.

[Heebs]

Mmm now to decide if I want to build this gun or not.