Paintball

[spearmint]

Hello everyone. I have a technical question about automags frame screws.
Is there a two different long type of them? Because I have 3 mags but one (it was complet Tac-One package, bought in Netherlands, two others I build from parts) have a longer screw then others. And thats my problem, I have damaged screw hole on others bodies and a shorter one screw doesn't fit. But when I use a longer one It's ok.

Maybe is there a difference between ULE/Tac bodies made from alluminium and classic steel bodies. It's possible, that steel bodies come with short screw and alluminium come with longer one???

I really need answer and two longer one frame screw, here in Europe its really hard to find them


Thanks

[Otter]

The ULE / Tac Aluminum bodies have a longer screw, and the steel bodies have a shorter screw according to AGD's website. Hope it helps!

[spearmint]

Thanks a lot, it was wery helpfull, thank you again.

And is there any place where I can buy it?

Need 3x the longer one (for ULE/TAC - alluminium)

Or better, If can somebody buy it and send it to my (to Europe, like a letter) I can pay for it extra cash (pay-pal), tell me how much you want. Here its really hard to find it

Thanks

[Spider!]

Originally Posted by spearmint

Thanks a lot, it was wery helpfull, thank you again.

And is there any place where I can buy it?

Need 3x the longer one (for ULE/TAC - alluminium)

Or better, If can somebody buy it and send it to my (to Europe, like a letter) I can pay for it extra cash (pay-pal), tell me how much you want. Here its really hard to find it

Thanks

Are able to grind/shorten a screw?

My local store has lots of the right kind of screws, but I couldn't say what the exact length of the ULE screw is supposed to be. I always fit them to the body, and I don't know if I actually have an official AGD body screw anywhere. I'm pretty sure there are some I haven't cut and ground.

[need4reebs]

i measured the screws for both and the classic/SS front frame screw is 3/4" and the RT/ULE front frame screw is 7/8" if that helps?

[Spider!]

Originally Posted by need4reebs

i measured the screws for both and the classic/SS front frame screw is 3/4" and the RT/ULE front frame screw is 7/8" if that helps?

That's easy enough. How much does it cost to send $3 of screws to Slovakia?

There's a joke in there somewhere.

[need4reebs]

[spearmint]

Thanks a lot, no there is no joke
I really need 3 pieces of them (for ULE) I cant get it here

Here is a picture both of them (with cm ruler)


Just tell me how much you want for your way to store, your time and screws.
I think that postage cannot will be more then 10$.
And sure I can cut down it If it will be linger then I need.
I appreciate very much for your helping

[Spider!]

Only three longer ones?

If the envelope is machinable or not, a few more probably won't make much difference.

I accept Czechs.

Pm me your address. I would rather trade for anything Eastern European, but euros will work if nothing else.

First class envelopes look pretty cheap actually.

[spearmint]

PM'd and thx for your help