| ||Thread Tools||Search this Thread|
|05-01-2013, 04:39 PM||#1 (permalink)|
Not Banned Kerry
Cocker Adapter Measurements
Trying to fit a ramrod barrel on my minimag, first i need to convert the threads. I know both doc and techT make adapters, but how mich do either of them push the barrel forward? My barrel just barely wont clear due to the OD being larger than the ID of thr body, but half an inch might make it able to clear.
|05-01-2013, 06:02 PM||#2 (permalink)|
Join Date: Dec 2008
Location: Houston, TX
Doc's adapter sets the end of the barrel just on the other side of feed port. If you need a 1/2" off of the bolt face, it will get it. It is about 3/4" to 1" from the bolt face to where the end of the barrel sits in the adapter. If you can see the end of your barrel in the feed port, no problem.
I can measure it if needed and Doc doesn't drop in.
some things are stickier than others
|05-01-2013, 09:04 PM||#5 (permalink)|
Did you want one that extends past the end of the minimag body?
|Thread Tools||Search this Thread|