Bolt?

r1dv · 06-15-2009, 09:00 PM

Can I use a lvl 10 bolt on a classic mag valve? And is it normal for bolt to wear out after a while because the lip of my lvl 7 bolt is chewed up a bit causing it to slip when i fire using auto-response trigger frame that i just installed.But it fires OK with the single shot trigger frame.

secretweaponevan · 06-15-2009, 10:17 PM

A level 10 bolt will work fine on your classic valve.

Not normal. Sounds like the trigger rod was set too close to the back of the trigger, or the auto-response frame was adjusted wrong and the sear started nibbling the bolt.

Perhaps even too short an on/off pin.

r1dv · 06-15-2009, 11:23 PM

Where can I get a longer on off pin?

onecaribou · 06-16-2009, 09:15 AM

AGD sells them.

06-15-2009, 09:00 PM	#1 (permalink)
r1dv Active Member Join Date: Aug 2007	Bolt? Can I use a lvl 10 bolt on a classic mag valve? And is it normal for bolt to wear out after a while because the lip of my lvl 7 bolt is chewed up a bit causing it to slip when i fire using auto-response trigger frame that i just installed.But it fires OK with the single shot trigger frame.

06-15-2009, 10:17 PM	#2 (permalink)
secretweaponevan Marathoner Join Date: Aug 2007 Location: Pocono Lake, PA	A level 10 bolt will work fine on your classic valve. Not normal. Sounds like the trigger rod was set too close to the back of the trigger, or the auto-response frame was adjusted wrong and the sear started nibbling the bolt. Perhaps even too short an on/off pin. __________________ "You don't use science to show that you're right, you use science to become right." -xkcd 701 feedback

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

06-15-2009, 11:23 PM	#3 (permalink)
r1dv Active Member Join Date: Aug 2007	Where can I get a longer on off pin?

06-16-2009, 09:15 AM	#4 (permalink)
onecaribou Five four three two one Join Date: Mar 2008 Location: Columbia,SC	AGD sells them.