| ||Thread Tools||Search this Thread|
|10-27-2009, 08:00 PM||#1 (permalink)|
Join Date: Dec 2008
Location: Phx, AZ
Classic RT valve/ hard line fittingd
Are these hard to come by? Been searchign for a while, and no one seems to have one avail.
this is for the Air-through RT body/rail.
also need front hardline fitting, what size is it?
|10-27-2009, 10:27 PM||#3 (permalink)|
Five four three two one
Join Date: Mar 2008
I found high pressure fittings and some coated steel hardline (for car brakes) on ebay.
I'll see if I can find you some sizes when I have a chance. I believe I found the parts via McMaster-Carr and then googled for prices.
|10-28-2009, 10:08 PM||#4 (permalink)|
SmallParts.com: The Hardware Store for Researchers and Developers
A good source for small parts... I have used them for SS Hypo tube to make custom hard lines.
HYPO Tube S/S 304-RW 8GA .165 OD X .135 ID 36"
I used the exact same fittings that came on the Phantom VSC. The rubber hose that is used with the fittings for the phantom are a bit tight over the out side but I found it was easier to slide them from the phantom tube onto the Hypo tube. Also the inside diameter is much larger, thinner walled, on the hypo tube than the one that is delivered with the Phantom VSC.
I've noticed that Doc Nickel makes a fitting less hose and thought that I would like to try that the next time I need to make a hard line for a marker. I believe he is silver soldering the threaded part of a machined down fitting to the pre bent tube.
"Resist much, Obey little" - Walt Whitman
<\> Feedback Threads:
_/\_ AO, eBay, MCB
secretweaponevan ~ "That wasn't in the instructions. Don't try to outsmart physics. Read and follow the instructions."
secretweaponevan ~ "You did great with following the instructions. Just so you know, that puts you in the top 1%."
|10-29-2009, 09:41 PM||#9 (permalink)|
Just for Shiggles
Good luck with the RT search Tbaggin! Mann, I may be contacting you sometime in the future for some of that hardline stuff!
Steam & Origin: Redivulpis
|Thread Tools||Search this Thread|