mcarterbrown.com

mcarterbrown.com (http://www.mcarterbrown.com/forums/)
-   Airsmiths on MCB (http://www.mcarterbrown.com/forums/airsmiths-mcb/)
-   -   Mech. Pump arm help (http://www.mcarterbrown.com/forums/airsmiths-mcb/232208-mech-pump-arm-help.html)

Optikal_Flare 04-26-2013 10:30 AM

Mech. Pump arm help
 
Ok, first off I would like to thank whoever would take the time to help a (tinkerer) in need.

I appreciate the work that custom shops do, and im newbie when it comes to DIY.

so if you need to lighten up your day, this is what I did.

Im trying to to make a shortened pump arm for a half block bought the marker that was already half blocked but was used as pump now Im turning it into a mech since I already own multiple pump markers.

Mind you have no real shop experience, and I thought I could get by with a tiny hobby table vice and vice grips (notice the marks). And a die/tap set I picked up at Harbor frieght.

I guess what happened was that I lost the bite on the die and it wont cut the end of the rod for proper threading.

Yes im using a 10/32.

Im really open to criticisms tips and over all help. Or does any one have one for sale?

Thanks for looking.

http://img838.imageshack.us/img838/7917/pumparm.jpg

Rainman229 05-07-2013 10:15 PM

Buy your self a new rod. Then the trick to threading them for half block is don't cut first. Run the die down to past your cut point. Yes this means cutting a lot of useless threads. But the existing threads are true on the rod. So your start point is true. Then cut it. And clean the end. Now your left with a half block cocker rod.


All times are GMT -4. The time now is 12:08 AM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC