| Milling and tapping for spyder feednecks.
My Kapp Reflex body has a cocker threaded feedneck (the reversed male kind), that I'd like to get milled off and get the body tapped for spyder feednecks (two 10-32 holes?). Before you assume anything, the feedneck is milled from the same block of aluminum as the body, it is NOT pressed in. Milling it off would not compromise any structural integrity of the body, i'm assuming.
Who can mill off the old feedneck, and tap it for spyder threads?, and how much would this cost? I'm especially interested if Hvacman can do it, as i'm about to send the body to you for ano anyway.
This is only an idea, i'm toying around with it in my mind. The thing i'm worried about is hacking up a rare body, and the even rarer circumstance of a mistake during milling.
Last edited by Andrewliu6294; 05-07-2008 at 07:53 PM.
| 
05-07-2008, 06:38 PM
