Custom

[LagShock]

Ive got an old pgp that has been screaming for a set of pnus for years, and Ive only got one question left that I couldn't find an answer to elsewhere.

With an old style valve, is there a way to rig a front-mounted lpr for a reasonable cost? Im going for back-bottle, and with a ram on the left and valve tap on the right that doesn't leave any room for a lpr except for the front, or a t-fitting on the valve tap and a front facing lpr. Ive got a couple ideas of how it could be done, but after deciding against converting the garage for now I am contracting out the work.

That being said, any airsmiths available to do some work on a pgp? I would need the ram mount attached, the valve tapped and set up with a back-bottle asa, some way to install the lpr and the lower tube cut to expose the reg., a direct feed conversion (I havent decided between right and center feed yet) and the 3-way mounted inside the grip frame.

Id like to spend a little while talking about options so I can keep the cost down as low as possible, maybe I can do some of the work here to cut cost.

Thanks in advance!

[Clearush]

I have no ideal who has it now.

[LagShock]

I was thinking most of the airsmiths were packed with work. Ill drop this project on the back burner for a little while. Then again, my grizzly catalog did come in the mail yesterday....