Custom

[Eli]

Can any of you fellas make me a high quality stick feed? A 12 round 45* stick feed. I'm willing to pay up to $35. This will go on my RF Sniper.

PM me if you're interested in the job.

[Legion]

you mean the vertical kind? Like the early stick feeds?

[Eli]

I mean like if you were to put a tube into a 45* elbow, but nicer, please.

[BrianHindt]

You could make it yourself quite easily. You take 3/4" i.d. pvc pipe and stick a section of ten round tube in the end. Then stick a CCI feed cap on the end of the ten round tube sticking out. Paint it properly with good spray paint and sand after primer and each coat. If wanting shiny, paint with clear coats and sand them too. This of course works with a 1" elbow.

I made one a few years back if you want pictures. The paint doesn't scratch at all.

[kidneythief]

Or you could make it from 3/4" copper pipe and a 45* elbow. I usually solder mine but you could get by with some JB weld or super glue. Then follow Brians painting method.

-Jake

[Eli]

If you read my original post and the one immediately after it, I use words and phrases like, "high quality", "nice", and "nicer". I'm asking if any of the airsmiths here can make me a stickfeed worth $35 of their time; which will be infinitely nicer than what I can cobble together with $1.50 worth of crap I bought at Lowes.

Thanks,

-Eli

[pizzaluvr]

Yeah guys.. He's asking where to buy one. He doesn't want to make one.

OP--I would suggest Noxx, I've had great experience with his stuff.

[kidneythief]

Id help you out but I dont even have $35 worth of my own time currently.

Either way the method PPS uses for their $50+ dollar tubes is exactly as I described...except they Powdercoat theirs. I think you could cobble a $1.50 worth of crap together to make a rather nice Tube.

-Jake