Paintball

[Chappy]

thats ever been produced?

[Railgun]

It likely won't be tight enough......

On my Tagmaster I was looking at doing much the same sort of wire detent as I did on my cocker barrels. But the wall is too thin on the barrel. Now I'm looking at adding a Piranha rubber detent from the outside. Of course this means cutting through both the body and the barrel and threading the body to take the holding screw. But it's better than living with all the rollouts.

The other option is that the thin wall Trracer barrels may be able to accept having Wedgits pushed into the wall back in the little section behind the barrel.

And then there's the Ghetto solution... two or three strips of electrical or automotive trim striping tape for about 3/4 inch to hold the ball like poor man's Wedgits. And some folks use nail polish or paint to paint in some fingers like this to slightly deform the ball and hold it until pushed by the air.

[Chappy]

Not too worried about rollouts and such, I'll probably do the trim tape in my stock barrel. I'm just curious what the tighter bore aftermarket barrels are.

I'm thinking I remember hearing about BOA making a trracer barrel. Anyone know if I'm correct? I'd figure if they did, there's probably a .688.
Did J&J make a ceramic for them?