WGP Reg Questions
I have a stock WGP reg that I'm going to be selling w/a Tippmann on eBay and I have a couple questions. It's the kind that looks like a shorter version of a PPS Stabilizer.
I understand that pressure is adjusted by unscrewing the elbow and turning the screw inside. Which way do you turn it to increase pressure and vice versa?
Also, are these regs co2-friendly? Seeing as how it's on a Tippy, a buyer might expect to be able to use co2 on it and if doing so is unadvisable with this reg, I want to post a disclaimer on the auction.
I know they're not the best regs in the world, but is there anything else I should be aware of?
Thanks in advance for your help.
You don't have to remove the elbow, just the lower cap part. Turning the screw out increases pressure. They are pretty rugged and will work on CO2, but from my experiance are not all that consistant no matter what gas you use.
And a much-delayed "Thank you" to you, sir!
I think the lower cap might be seized or red Loctited on. There are scratches on it like the previous owner used vice grips or something to try to unscrew it.
My WGP regulators have always worked extremely well for me. I may not be pushing their performance limits on my pumps, but they seem to be rugged and well-designed.
Stock WGP were introduced before HPA became popular, they do a great job with CO2 tanks. The adjustment takes a bit of work, but once it's set you will never have to touch it again.
They have a higher flow rate than most regulators out, it was highly recomanded for running LP setup with a AKALMP Tornado valve, untill they came out with the 2 litre.
I use an older (2k maybe ?) WGP reg on my Sniper II and it seems to do a good job. Again, like Russc I'm not really going to ever get shootdown with it, since as it's on a Sniper.
mostly fine IMHO
not to continue to contradict hobbes but I have seent pretty good performance as well for the most part.
on a good day with decent/good paint my sniper II shoots +-2fps.
that is after I rebuilt the reg.
I had been getting strange performance from it before the rebuild. I could chrony in at +-2fps but then I would let it sit untill the first game and fire a few shots and then have my velocity drop to 140 fps or less. The reg seat was missing a decent chunk out of the side and would occasionally just not seal. The pressure would build up and pretty well seal my valve closed.
for setting the output pressure on these I recommend getting a spare ASA/bottomline and putting a guage on it (0-1500). then you can sit and tune your pressure with out even having it mounted. You will need to know the pressure that your valve/spring combo will like the best or just turn it to 450 as a general setting for a cocker/sniper.
|All times are GMT -4. The time now is 06:43 PM.|
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO
© MCB Network LLC