|
             |
 |
|
| Ask The Experts You ask the tough questions |
 |
| | LinkBack | Thread Tools | Search this Thread |
07-13-2007, 10:52 PM
| #1 (permalink) |
| Pumper  Join Date: Apr 2006 Location: Jax, FL  |  Half block question I just got a half block Sniper and I need a new hammer. Whoever did the "job" on the hammer did not do such a good job. Will I need a specific hammer? How can I tell what one I need? I don't know who did the work on it. Thanks Peace
__________________ DCB<>< John 14:6 CPPA #1092 Pump Gun Pimp #80 LPPC #164 Feedback http://www.mcarterbrown.com/forums/f...html#post78710 Gallery http://www.mcarterbrown.com/gallery/...er=184&cat=500  |
|  |
|
07-13-2007, 11:18 PM
| #2 (permalink) |
| MCB Member  Join Date: Jun 2007 Location: Belmont NH | it will need the slot in the top. however if it was a homemade job it might need to be matched up if everything doesnt line up. all depends on who and how they made it. if it is a factory made one you should be able to order one.
__________________ No one expects the Bear Calvary Feedback http://www.mcarterbrown.com/forums/f...-feedback.html customcockers.com http://www.customcockers.com/forum/s...ht=aaronlecain Phog http://idriders.com/ThePhog/index.php/topic,10.0.html |
|
| |
|
07-17-2007, 02:01 AM
| #3 (permalink) | |
| Post Whore  Join Date: May 2007 Location: Oregon | there not hard to do.. its just a standard cocker hammer with a slot milled in the top.. just take one to your local machinist, and have him use a 3/8 (I think) bit, and get the length and depth of the cut from Halfcocker.com.. they show the full halfblock conversion measurements..
__________________ Quote:
| |
|
| |
|
|
| Thread Tools | Search this Thread |
|
|
